Control Connectors And Pinouts - NDS 43'' RADIANCE G2 Bedienungsanleitung

Control Connectors and Pinouts

Pin Name Description
1 NC No Connection
2 RXD No Connection
3 TXD Flash, and Serial Control Tx
4 NC No Connection
5 GND Ground
6 NC No Connection
7 NC No Connection
8 NC No Connection
9 RXD Flash Upgrade and Serial Control Rx
General Purpose Input and Output (GPIO)
Swap:
Closing the Swap Pin to GND swaps the position and size of the Primary and Secondary images. See page
8 for details.
PIP Size:
The size of Secondary image increases each time the PIP Size is connected to GND. See page 8 for details.
Record Indicator:
The Record Indicator is displayed while a contact closure to the GND is present, the indicator is removed
when the contact is opened. The Record Indicator is displayed in the monitor's top left corner.
19
Serial Control
Mating connector:
Telephone Handset
Pin Name Description
1 Swap Swap P & S inputs
2 P.S. PIP Size.
3 R.I. Record Indicator.
4 GND Common Ground
Pin Name
1 VCC
2 D-
3 D+
X ID
4 GND
Note:
Flash Upgrade Cable part number: 35Z0047
is available from NDS.
GPIO
RJH 4 pin
USB
Connector
Description
+5 VDC
Data -
Data +
N/C
Ground