Gpio - NDS 43'' RADIANCE G2 Bedienungsanleitung

GPIO

General Purpose Input Output (GPIO):
The GPIO control allows the user to step through the Secondary image sizes as described on page 8, swap
the Primary and Secondary images or display a Record indicator in the upper left corner of the display.
Refer to the Input Menu shown below when setting up the Primary and Secondary inputs.
GPIO Primary / Secondary Source Setup:
1. Press the INPUT button twice to open the
2. Press the SCROLL button to highlight the input that will be designated as Primary.
3. Select it by pressing the ◄ button a P appears in the column to the left of the cursor.
4. After the Primary input is chosen you may designate a
5. Press the SCROLL button to highlight the input that will be designated as Secondary.
6. Select it by pressing the ► button an S appears in the column to the right of the cursor. The selected
Secondary input appears as a small PIP in the upper right corner of the display.
input may be cleared by highlighting it using the SCROLL button and pressing the ►
7. The Secondary
button again.
Using GPIO Control Fixture:
1. Connect an appropriately wired fixture to the GPIO connector.
2. Press the fixture's PIP Size
3. The display will cycle through the PIP sizes. See page 8 for the sequence.
4. Press the fixture's Swap button. The
5. Press the fixture's Record button, the
Note: GPIO connector pin out is on page 19.
Priority Input Select
Setup:
By default the Priority Input Select
preselected.
If the Priority Input Select
selected before the feature may be re-enabled. After selecting the secondary (PIP) input, press and hold
the INPUT button for 3 seconds. When the
Select On" message appears in the middle of the screen for about 2 seconds, the PIP image is placed
behind the primary, the PIP + and -
enabled. When Priority Input Select
Operation:
When Priority Input Select
displayed image. If the primary signal is restored, its image becomes the displayed image again, and the
secondary image is placed behind the primary image. If both the primary and secondary signals are lost,
the monitor alternately scans the primary and secondary inputs until a signal is detected on one of them.
When a signal is detected on the primary or secondary input, its image is displayed on the monitor.
9
Input Menu.
button.
Primary and
Record indicator is displayed until the Record button is released.
feature is enabled with the Primary (DVI) and Secondary (SDI) inputs
feature has been disabled, then a secondary input (pages 7 and 8) must be
Priority Input Select
) buttons are disabled, and the SWAP button remains
(◄ and ►
is enabled, holding the INPUT button down for 3 seconds disables it.
is enabled and the primary signal is lost, the secondary input becomes the
Secondary input.
Secondary images swap locations
feature becomes active, a "Priority Input