Checking The Battery Charge Level; Use; Switching On And Off; Setting The Speed/Tightening Torque - Parkside PDSSA 20-Li A1 Originalbetriebsanleitung

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram) .
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Use

Switching on and off

Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in .
The LED work light
OFF switch is depressed lightly or fully . This
allows for illumination of the work area in low
lighting .
Switching off:
♦ Release the ON/OFF switch
appliance .

Setting the speed/tightening torque

♦ Press the ON/OFF switch
speed/tightening torque . Increasing the pressure
increases the speed/tightening torque .
■ The tightening torque depends on the selected
speed and impact duration .
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
NOTE
► The integrated motor brake ensures rapid
stoppage .

Changing the direction of rotation

♦ Change the direction of rotation by pressing the
rotational direction switch
or right .
PDSSA 20-Li A1
to check
as follows:
lights up when the ON/
to switch off the
lightly for a low
towards the left

Inserting the bits

♦ Insert the adapter
tool holder .
♦ To do this, pull the locking sleeve
and allow the adapter
engage .

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance­free .
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ Never allow liquids to get into the appliance .
■ Use a soft, dry cloth to clean the housing .
Never use petrol, solvents or cleansers which
can damage plastic .
■ If a lithium­ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline .
or bit holder into the
backwards
or bit holder to
31
GB│MT │
■