Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Switching On/Off; Setting/Preselecting The Rotation Speed/Tightening Torque - Parkside PDSSAP 20-Li A1 Originalbetriebsanleitung

Inserting/removing the battery pack

Inserting the battery pack
♦ Set the rotation direction switch
position (lock). Snap the battery pack
the handle.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the charge level of the battery (see also
main diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Switching on/off
Switching on
♦ Press and hold the ON/OFF switch
the tool.
The LED work light
OFF switch is pressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦ Release the ON/OFF switch
appliance.
50
GB │ MT
│
■
to the middle
into
and remove the
to
as follows:
to start
lights up when the ON/
to switch off the
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque preselection button
the required torque incrementally. The selected
torque is shown on the torque display .
♦ Pressing the ON/OFF switch
low speed. Increasing the pressure increases
the speed/tightening torque.
♦ The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
► When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
► The integrated motor brake ensures rapid
stoppage.
ATTENTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!

Changing the direction of rotation

♦ Change the direction of rotation by pushing the
rotation direction switch

Inserting/replacing tools

♦ Pull the locking collar
suitable tool into the tool holder .
♦ Pull the locking collar
remove the tool.
to select
lightly yields a
to the right or left.
backwards. Insert a
1a
backwards again to
1a
PDSSAP 20-Li A1