Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦
Push the rotation direction switch
middle position (lock) . Push the battery pack
into the handle until it clicks into place .
Removing the battery pack:
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
the status of the battery (see also main diagram) .
The status/remaining charge will be shown
on the battery display LED
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on:
♦
To start the appliance, press the ON/OFF
switch
and keep it pressed in .
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions .
Switching off:
♦
Release the ON/OFF switch
appliance .
Setting/preselecting the rotation
speed/tightening torque
♦
Press the torque preselection button
the required torque in stages .
♦
Press the ON/OFF switch
speed/tightening torque . Increasing the pres-
sure increases the speed/tightening torque .
■
The tightening torque depends on the selected
speed/torque preselection and impact duration .
PASSK 20-Li A1
into the
and remove the
to check
as follows:
lights up when the
is depressed lightly or fully .
to switch off the
to select
lightly for a low
NOTE
►
However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening .
CAUTION!
♦
The tightening torque actually attained must
always be checked with a torque wrench!
NOTE
►
The integrated motor brake ensures rapid
stoppage .
Changing the direction of rotation
♦
Change the direction of rotation by pressing
the rotation direction switch
or right .
Fitting the socket
♦
Push one of the supplied sockets
tool holder
.
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch off the appliance and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free .
■
The appliance must always be kept clean, dry
and free from oil or grease .
■
Never allow liquids to get into the appliance .
■
Use a soft, dry cloth to clean the housing .
Never use petrol, solvents or cleansers which
can damage plastic .
■
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
NOTE
►
Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline .
towards the left
onto the
GB │ IE │ NI
│
7
■