Use only the following high-speed battery
charger to charge the cordless tool:
PLG 20 A1
INPUT:
Rated voltage:
Rated power
consumption:
Fuse (internal):
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Protection class:
Noise emission value:
Noise measurement value determined in accord
ance with EN 62841 . The Arated noise level
of the tool is typically:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 62841:
Tightening screws and nuts of maximum
permissible size:
a
= 8,65 m/s
2
h
Uncertainty K = 1 .5 m/s
Wear hearing protection!
NOTE
►
The vibration level specified in these instruc
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons . The
specified vibration emission value can also
be used to make an initial exposure estimate .
PDSSA 20-Li A1
230–240 V ~ , 50 Hz
(AC)
65 W
T3.15A
3 .15 A
21 .5 V
(DC)
2 .4 A
approx . 60 min
II / (double insulation)
L
=
91,6
dB (A)
PA
K
=
3
dB
PA
L
= 102,6
dB (A)
WA
K
=
3
dB
WA
2
WARNING!
►
The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases . Regular use of the power tool
in this way may cause the user to underesti
mate the vibration . Try to keep the vibration
loads as low as possible . Measures to reduce
the vibration load are, e .g . wearing gloves
and limiting the working time . Wherein all
states of operation must be included (e . g . times
when the power tool is switched off and times
where the power tool is switched on but
running without load) .
General Power
Tool Safety Warnings
WARNING!
►
Read all safety warnings, instructions, il
lustrations and specifications provided with
this power tool. Failure to follow all instruc
tions listed below may result in electric shock,
fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mainsoperated (corded) power tool or
batteryoperated (cordless) power tool .
1 . Work area safety
a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of flam
mable liquids, gases or dust. Power tools cre
ate sparks which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
27
■
GB│MT │