Battery Tool Use And Care; Service; Safety Instructions Specifically For Impact Screwdrivers - Parkside PDSSA 20-Li A1 Originalbetriebsanleitung

that may affect the power tool's operation. If
damaged, have the power tool repaired be­
fore use. Many accidents are caused by poorly
maintained power tools .
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control .
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions, tak­
ing into account the working conditions and
the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation .
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow
for safe handling and control of the tool in unex­
pected situations .

5 . Battery tool use and care

a) Recharge only with the charger specified by
the manufacturer. A charger that is suitable for
one type of battery pack may create a risk of
fire when used with another battery pack .
b) Use power tools only with specifically desig­
nated battery packs. Use of any other battery
packs may create a risk of injury and fire .
c) When battery pack is not in use, keep it away
from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal
objects, that can make a connection from
one terminal to another. Shorting the battery
terminals together may cause burns or a fire .
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water.
If liquid contacts eyes, additionally seek medi­
cal help. Liquid ejected from the battery may
cause irritation or burns .
e) Do not use a battery pack or tool that is
damaged or modified. Damaged or modified
batteries may exhibit unpredictable behaviour
resulting in fire, explosion or risk of injury .
f) Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire
PDSSA 20-Li A1
or temperature above 130 °C (265°F) may
cause explosion .
g) Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instruc­
tions. Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire .
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries!
Protect the rechargeable battery from
heat, for example from continuous
exposure to sunlight, fire, water and
moisture. There is a risk of explosion .

6 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace­
ment parts. This will ensure that the safety of
the power tool is maintained .
b) Never service damaged battery packs. Service
of battery packs should only be performed by
the manufacturer or authorized service providers .
Safety instructions specifically for
impact screwdrivers
■ Wear hearing protection when impact screw­
ing. Exposure to loud noise can lead to hearing
loss .
■ Secure the workpiece! A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand .
■ Hold the power tool firmly. High torques can
occur for brief periods while tightening and
loosening screws .
■ Wait until the power tool has come to a stand­
still before putting it down. The tool can jam,
this leading to loss of control of the appliance .
29 ■
GB│MT │