Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig . A); Attaching/Disconnecting The Battery Pack To/From The Appliance - Parkside Pdssa 20-Li A1 Originalbetriebsanleitung

■ Hold the power tool by insulated gripping sur­
faces, when performing an operation where
the fastener may contact hidden wiring. Fasten­
ers contacting a "live" wire may make exposed
metal parts of the power tool "live" and could
give the operator an electric shock .

Safety guidelines for battery chargers

This appliance may be used by chil­
■
dren aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super­
vision or have been told how to use
the appliance safely and are aware
of the potential risks . Do not allow
children to use the appliance as a
toy . Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised .
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person .
The charger is suitable for indoor use
only .
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac­
turer, their customer service department or a
similarly qualified person .
ATTENTION!
Hot surface .
Risk of burns .
■ 30
│ GB│MT

Before use

Charging the battery pack (see fig . A)

CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
■ Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
♦ Connect the battery pack
charger (see Fig . A) .
♦ Insert the power plug into the socket . The control
LED lights up red .
♦ The green control LED
charging process is complete and the battery
pack is ready .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
♦ Insert the battery pack
ance .
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch
middle position (lock) . Allow the battery pack
to click into the handle .
Removing the battery pack:
♦ Press the release button
battery pack .
to the rapid battery
indicates that the
flashes, this means
has overheated and
both
is
back into the appli­
into the
and remove the
PDSSA 20-Li A1