Commissioning; A) Removing The Car Body; B) Installing The Receiver Aerial Cable; Inserting The Driving Battery In The Vehicle - Reely Blue Tanga Bedienungsanleitung



9. Commissioning

a) Removing the Car Body

The car body is secured with fastening clamps that must be pulled from the holding pins. The car body can then be
lifted off.

b) Installing the Receiver Aerial Cable

The receiver's aerial cable is normally rolled up on delivery. Unwrap the aerial cable completely and smoothen it
carefully. For this, hold the aerial cable near the receiver with two fingers (do not hold the receiver but the cable) and
then pull the cable straight repeatedly with two fingers of your other hand.
Now insert the aerial cable from below through the attachment (possibly already performed by the manufacturer).
Guide it through the aerial tube and plug the aerial tube into the respective attachment mount on the vehicle. Simply let
excess aerial cable protrude loosely from the tip of the aerial tube.
If a rubber cap for the aerial tube is enclosed, it prevents the dislocation of the aerial cable after it is attached to the tip.
Make sure that the aerial cable does not enter the drive. Never shorten the aerial cable! Never roll up the
aerial cable! This reduces the range extremely.
c) Inserting the Driving Battery in the Vehicle
Attention!
The driving battery must not be connected to
the speed controller yet!
To insert the driving battery, open the battery compartment
cover on the underside.
First pull the holding clip (A) from the retaining pin (B). Then
pull out the retaining pin.
Now insert a driving battery. The connecting cable of the
battery pack is installed upwards through the opening (on
the side of the connector of the speed controller).
Re-attach the battery compartment cover properly, stick the
retaining pin (B) into the opening (either from the right or
from the left) and lock the retaining pin using the holding
clip (A) previously removed.
40
B
B
A
A
Figure 2