B) Charger; Before Commissioning; During Operation - Reely Beginner Falcon V2 Bedienungsanleitung

b) Charger

• Set-up of the mains adapter is constructed pursuant to protection class II.
• Use only a proper mains socket of the public supply mains for voltage/current supply.
• The mains socket to which the charger is connected must be easily accessible.
• The supplied charger must only be used for the enclosed LiPo flight battery. Never try charging other batteries!
There is a risk of fire and explosion! The charger is not suitable for charging batteries in the remote control trans-
mitter!
• Protect the charger from moisture and wetness as well as from damage.
If the connected charger has become moist or wet or damaged, do not touch it. Danger to life from electric
shock!
First deactivate all sides of the mains socket to which the charger is connected (e.g. switch off the respective
fuse or turn out the fuse. Then deactivate the fault interrupter protection switch).
Only then pull the mains cable of the charger from the mains socket; no longer use the charger, but dispose
of it environmentally compatibly.
c) Before Commissioning
• Always first switch on the transmitter and then connect the flight battery to the helicopter. This is the only way for
an attunement function to take place between transmitter and receiver, so that your model will react reliably to the
control commands of your transmitter.
• Check the functional reliability of your model and of the remote control system. Watch out for any visible damage
such as defective plug connections or damaged cables. All moving parts on the model must run smoothly but must
not have any tolerance in the bearing.
• The flight battery, which is necessary for operation, as well as the rechargeable battery needed in the remote control
must be charged before operation.
• If batteries are used as a transmitter power supply, make sure that they have sufficient remaining capacity (trans-
mitter indication). If the batteries are empty, always replace the complete set, never individual cells only.
• Before operation, always control the settings of the trim slider on the transmitter for the various steering directions
and, if necessary, adjust them.
d) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment depends completely
on your responsible use of the model.
• Improper operation may cause serious injury and property damage! Therefore make sure to keep a sufficiently safe
distance from persons, animals or objects during operation. Never try to grab the flying model with your hand!
• Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medication can
cause incorrect responses.
• The drive motor, flight controller and flight battery can heat during operation. For this reason, wait for 5 to 10 minutes
before recharging or replacing the flight battery or taking off again with a second, already-charged flight battery.
57