Kärcher WRS 200 Handbuch Seite 26

11.3 Adjusting the dosage
The dosage is set at the factory for water hardnesses of up
to approx. 30 °dH (position between 1 and 2). Change the
position if necessary.
Bar
1
Cover
2
1. Remove the bar by removing the 2 screws (marked with
arrows) using a socket wrench.
2. Remove the cover.
Cover
1
Dosing pump
2
Position 1
3
Note
Up to 10 °dH
Position 2
4
Note
Up to 55 °dH
3. Adjust position 1 to 2 for the desired degree of water
hardness.
Higher positions are irrelevant because these degrees
of hardness do not occur.
4. Attach the cover.
5. Attach the bar.
26
12 Startup
WARNING
Risk of injury from high-pressure jet or electric shock.
Check that the device, accessories, supply lines and con-
nections are in a correct condition before using the device.
Only use the device when it is in a correct condition.
12.1 Connect the high-pressure hose and high-
pressure gun
The high-pressure hose is stored in a storage compart-
ment behind the right-hand door.
The high-pressure gun with spray lance is located in hold-
ers attached to the left front side of the WRS 200.
High-pressure hose
1
High-pressure gun
2
Left door rubber latch
3
Door handle
4
Holder with rubber latch
5
Spray lance
6
Mounting
7
1. Release the rubber latch on the right-hand door (at the
top side) and open the door.
2. Remove the high-pressure hose.
3. Release the rubber latch from the upper holder.
4. Remove the high-pressure gun with spray lance.
5. Connect the high-pressure hose to the high-pressure
gun.
High-pressure hose
1
WRS 200 high-pressure connection
2
Switchover valve
3
Upper position: Operation with high-pressure gun
Lower position: Operation with high-pressure gun
closed
Lower position (with front bar option): Switchover to
front bar operation
Water hose to water connection
4
English