Kärcher WRS 200 Handbuch Seite 25

a Platform C: Attach using the existing retaining pins on
the vehicle and secure with the clips (see illustration).
b Platform D: Attach to the vehicle using screw, washers
and nuts (included in the delivery).
8. Adjust the position of the WRS 200 using the adjusting
nuts and secure with the counter-nuts.
11 Pre-commissioning
WARNING
Risk of injury
Check that the battery, accessories, supply lines, water fil-
ter and connections are in a correct condition before using
the device.
Only use the device when it is in a correct condition.
1. Check the filling level in the fuel canister and fill if nec-
essary.
2. Check the filling level in the system care container and
fill with RM 110 if necessary.
3. Check the filling level in the water tank and fill if neces-
sary.
4. A licence plate (repeater licence plate) must be attached
before use on public roads. The license plate must be
attached centrally with a 40 mm clearance, parallel to
the tail lights.
11.1 Refuelling
DANGER
Explosion hazard due to overflowing fuel
Take care ensure that no fuel spills onto hot surfaces when
refuelling.
DANGER
Explosion hazard due to smoking and naked flames
Ensure strict prohibition of smoking and open flames dur-
ing the refuelling procedure.
WARNING
Health risk from inhaled vapours
Do not refuel in confined spaces.
ATTENTION
Risk of damage due to incorrect fuel
Refuel with Diesel only.
ATTENTION
Risk of damage due to the fuel pump running dry
Check the filling level of the fuel canister regularly, refuel in
time as necessary.
Note
Refill with fuel only when the canister is detached. Use only
original canisters.
Left-hand door
1
Fuel canister
2
Retaining strap
3
Tank cap with fuel lines
4
Detergent container
5
1. Release the rubber latch on the left-hand door and open
the door.
2. Release the retaining strap from the canister.
3. Open the tank cap and allow any fuel to drip off before
removing the cap.
4. Fasten the tank cap with fuel lines open at the top.
5. Remove the canister.
6. Refill with Diesel.
7. Insert the canister and secure with the retaining strap.
8. Fit the tank cap with fuel lines.
9. Close the tank cap.
10.Wipe off any spilt fuel.
11.Close the left-hand door and secure with the rubber
latch.
11.2 Filling the system care container
The RM 110 system care liquid (descaler) is a highly effec-
tive agent for preventing calcification of the heating coil
when operating with hard water. This is drip-fed dosed into
the water supply.
The dosage is set at the factory for water hardnesses of up
to approx. 30 °dH. The dosing valve can be adjusted if nec-
essary. See chapter "Adjusting dosage".
ATTENTION
Health risk
Observe the safety and handling instructions for handling
RM 110.
System care container
1
Cover
2
1. Open the lid of the system care container.
2. Add RM 110 system care liquid to the container, do not
overfill.
Maximum filling level is 2 cm below the filling edge.
3. Close the cover.
English 25