Kärcher WRS 200 Handbuch Seite 24

3. Use screws with washers and nuts.
At the mount side: Fit the outer screw without a washer.
4. Attach the right-hand mount in the same manner.
9 Upper link position
The upper link must be attached differently for platform C
and platform D.
Position for platform D
1
Position for platform C
2
Screw
3
Stop nut
4
Upper link
5
1. Attach the upper link in the corresponding position using
a screw and stop nut.
10 Fitting and connecting the WRS 200
The WRS 200 is attached to the adapter with coupling tri-
angle and secured by a screw.
It is additionally fastened to the vehicle by the upper links.
We recommend using the help of a second person for at-
taching the device.
WRS 200
1
Lift truck
2
Adapter with coupling triangle
3
1. Use the lift truck to position the WRS 200 approximately
30 cm in front of the adapter and then lift it until it is po-
sitioned above the adapter.
24
Hydraulic hoses
1
Water connection
2
Cable with plug
3
2. Connect the hydraulic hoses to the WRS 200 and insert
them into the PTO hydraulic connection on the vehicle
(observe the correct flow direction).
3. Connect up the water hose.
4. Insert the cable with plug into the trailer socket.
Screw (retainer)
1
WRS 200
2
5. Slowly move the WRS 200 forwards as far as it will go
and then lower it into the adapter coupling triangle.
6. Secure the WRS 200 with the screw. Tightening torque
80 Nm.
Upper link adjusting nut
1
Lock nut
2
Retaining pin with retaining clip (platform C)
3
7. Attach the left-hand and right-hand upper links to the ve-
hicle.
English