Terminal Temporary Disable/Enable; Terminal Permanent Disable; High/Low Audio Toggle; Using High Audio - Motorola MTP850 FuG Ausführliche Bedienungsanleitung

Feature User Guide

2.19 Terminal Temporary Disable/Enable

Your radio is provided with a feature that allows your service provider to disable it temporarily in case it is stolen.
When your radio is disabled or is powered up in disabled state, it looks and acts like it is turned off.
If your radio is found, your service provider can enable it again over the air. After your radio is enabled, you
may resume normal operation.

2.20 Terminal Permanent Disable

Your radio is provided with a feature that allows your service provider to disable it permanently in case it is stolen
or lost. When your radio is disabled permanently, it becomes inoperable. After a Permanent Disable your service
provider cannot enable your radio. It is recommended to Permanent Disable your radio only when you do not expect
to recover it. If it is recovered then a Permanent Disable radio can be reactivated by returning it to Motorola.

2.21 High/Low Audio Toggle

The user is able to switch from the external earpiece to the main speaker using SPEAKER CONTROL key and is
not required to disconnect the external earpiece or PHF.
The states of the routed audio are:
• Speaker HIGH — indicates that audio is routed to the main speaker.
• Speaker LOW — indicates that audio is routed to the earpiece or PHF earpiece, and not to the main speaker.

2.21.1 Using High Audio

When and where to use:
Use it when placing and receiving a Group, Phone and Private calls.
Procedure Steps
1 Hold your radio in a vertical position with its top microphone 5–10 centimeters away from your mouth.
2 Speak into the top microphone and listen through the internal speaker.
Keep the antenna at least 2,5 centimeters from your head and body.

2.21.2 Using Low Audio

When and where to use:
Use it when placing and receiving a Phone, PABX, and Duplex Private calls.
2-20 -