Enter Fusion Data Manual Z30 On/Off; Job Number Z40 Z41; Enter Job Number Manually Z42 On/Off; Infotext Z43 On/Off - Georg Fischer Piping Systems MSA Plus 400 Betriebsanleitung

4 Configuration
20
«Identification Required» mode, the operator will be requested to enter his
operator identification barcode before fusion can begin. In the «Identification
Voluntary» mode, the operator can enter his identification barcode if desired,
but it this is not necessarily required (see chapter 3.1) .
4.4

Enter Fusion Data Manual Z30 ON/OFF

The barcode «Enter Fusion Data Manually» Z30 ON activates the option to
enter data by hand. Z30 OFF deactivates this option.
4.5

Job Number Z40 Z41

The barcodes Z40 «Job Number Voluntary» and Z41 «Job Number Required»
configure whether a job number is required for fusion. This option functions in
the same way as the operator identification option (see chapter 3.2) .
4.6

Enter Job Number Manually Z42 ON/OFF

The operator is able to enter the job number by hand with the barcode setting
Z42 ON, this option is blocked with setting Z42 OFF (see chapter 3.2) .
4.7

Infotext Z43 ON/OFF

The operator is able to enter the infotext by hand with the barcode setting Z43
ON, this option is blocked with setting Z43 OFF.
This function allows the operator to make an input of two strings by keyboard
before each start of a fusion. The two text strings will be stored in the
MSA Plus 400 together with all the other relevant fusion data.
The title, displayed during the entry of the text, is part of the configuration
barcode Z43. The configuration barcode is generated by the program
MSA WIN-WELD (see chapter 3.4) .
(10.07)
Operating instructions MSA Plus 400
MSA Plus 400_e.doc