Enter Job Number; Query Fusion Preparation - Georg Fischer Piping Systems MSA Plus 400 Betriebsanleitung

Operating instructions MSA Plus 400
3.2

Enter Job Number

If the configuration «Job Number Required» (Z41) is activated, the display will
ask the operator to enter the job number from the job barcode.
JOB NUMBER:
???
UP DWN
The job number is stored in memory until the date changes. It can be erased
by entering the same job barcode or by entering a different job barcode.
3.3

Query Fusion Preparation

If the configuration «Query Fusion Preparation» (Z0) is activated, the following
confirmations will be requested after entering the fusion data:
SCRAPED/CLEAN?
TEMP. OK?
UP DWN
Press ENTER, if the pipe ends are scraped and cleaned.
Depending on whether a clamp is being used or not, answer the following
questions with «YES» or «NO». Select «YES» or «NO» by pressing the right
button and confirm with ENTER.
CLAMPING TOOL?
UP DWN
(10.07)
LFT RGT ENT
<YES>
LFT RGT ENT
<YES>
LFT NXT ENT
MSA Plus 400_e.doc
3 Additional Functions
MSA Plus 400
CF
GB 14:20
03-06-2007
MSA Plus 400
CF
GB 14:20
03-06-2007
MSA Plus 400
CF
GB 14:20
03-06-2007
11