Getting Started - Yamaha VS10 Bedienungsanleitung

Checking the Package Contents
Check that the following accessories are included in the package.
Remote control Batteries (AAA, R03, UM-4 type)
ON/OFF
EFFECT
VS10 TV VCR SAT
P
– +
VOL VOL
P
Audio connection cord
SET
DSP INPUT
(2 pin, 1.5 m)
MEMORY
1 2 3
4 5 6
7 8 9
MENU
– +
- -- 0
/ C/P
SUBWOOFER SUBWOOFER
– +
TEST
NIGHT MODE
Video connection cord (1.5 m)
Readying the Remote Control
Inserting the batteries
1
Remove the battery compartment cover.
2
Insert the four batteries (AAA, R03, UM-4 type)
with + and – oriented properly.
3
Close the battery compartment cover.
2

GETTING STARTED

Connection guide
Connecting to a TV (monitor), DVD player, Satellite tuner and VCR
Connection Guide
Control center VS-10 (rear panel)
VIDEO SIGNAL
MONITOR
OUT
V
DIGITAL 1 VIDEO 1 TV
(V/PCM)
INPUT
V
DVD player
V R L R
VIDEO OPTICAL DIGITAL
OUT OUTPUT
V R
L
Satellite tuner VCR
L VIDEO
OUT
R
VIDEO AUDIO
OUT OUT
Supplied cords
V
Audio connection cord (2 pin) (x 1)
L L
R R
Video connection cord (x 1)
V V
Commercially available cable
Optical fiber cable
Precautions regarding batteries
Misuse of dry cell batteries may result in leakage or
bursting. Be sure to follow the precautions given below.
• Insert batteries with (+) and (–) oriented according to the
marking in the battery compartment.
• Do not mix old and new batteries.
• Do not mix different types of batteries as they may offer
different voltage and performance even though they have
the same shape.
• Remove all batteries when they can no longer be used or
when the remote control will not be used for an extended
period.
• Do not use rechargeable batteries.
• If leakage occurs, wipe away all battery fluid inside the
compartment.
Preserving the manufacturer code
Replace batteries early before they become unusable.
The manufacturer code set by the user will be preserved
for about two minutes when batteries run out or when
they are removed. Note that the manufacturer code
setting may be lost if more than two minutes elapses.
Installation attachments
for the control center
+ – +
DO NOT CONNECT THIS UNIT TO MARK
SPEAKERS OTHER THAN NX-VS10M
MAIN SPEAKERS
OUT SYSTEM
SUBWOOFER CONNECTOR
L V
TV (monitor)
AUDIO
OUT
L
R
V L R
L R
1 L
2 R
VIDEO AUDIO AUDIO
IN IN OUT
V L R
Supporting stand
Side pads (x 2)
Bottom pads (x 4)