Yamaha VS10 Bedienungsanleitung Seite 30

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL
Precautions when performing
preset
The transmission indicator goes out once the manufacturer
code is set properly.
If the transmission indicator does not go out, or if it flashes
and then goes out, repeat the procedure from step 1.
Pay attention to the following points when you repeat the
preset procedure.
• Check the manufacturer code number.
• Check that the correct remote control selector button has
been selected when setting the manufacturer code.
• If more than one code is given for a manufacturer, try
entering each code in the order given.
• Remove and replace the remote control's batteries
(complete this step within 2 minutes) and then repeat the
procedure.
When the remote control does not
work correctly
When the remote control does not work correctly, try to
enter the other manufacturer codes.
To clear a manufacturer code
Perform the procedure "Setting the Manufacturer Code"
described on page 27 and enter the following codes when
you reach step 3.
• To clear the "TV" button: 0000
• To clear the "VCR" button: 0000
• To clear the "SAT" button: 0000
• To clear all buttons: 9990
28