Connecting The Loudspeakers - Clatronic dvd 628 hc Bedienungsanleitung

This cleverly designed DVD receiver produces ideal
sound quality when the loudspeakers are used within
their nominal impedance range.
Important
• The minimum impedance of the fi ve loudspeakers is
6 ohms; for the subwoofer it is 8 ohms.
• If you would like to use only one loudspeaker or
listen to the music in mono, you should not connect
the individual loudspeakers on the left and right of
the channel connections in parallel.
05-DVD 628_GB 39
CONNECTING THE LOUDSPEAKER SYSTEM
Connecting the Loudspeaker Cables
1. Remove approximately 1 cm of the cable insulation.
2. Turn over the cable end.
3. Open the cable clamp by pressing the lug.
4. Insert the end of the cable into the clamp.
5. Release the lug and check whether the cable is fi rmly
in the clamp.
Note:
In order to avoid a short circuit, care must be taken that
when the loudspeakers are connected the plus and
minus poles of the loudspeaker cables are connected
accordingly.
39
30.08.2004, 15:41:58 Uhr