Connecting The Video Cable - Clatronic dvd 709 Bedienungsanleitung

Layout Clatronic.book Seite 58 Donnerstag, 9. Februar 2006 9:41 09
Starting up

Connecting the Video cable

Fig. 4
Fig. 5
Fig. 6
Fig. 7
58
The video cable transmits the video data from your DVD-Player to
the TV or the Video-Projector.
There are four different ways of connecting the DVD-Player with
your TV/Video-Projector. Select one of these possibilities to suit your
replay unit.
NOTE:
If you do not use a SCART-Connection, you must set up an
additional Audio-Connection to transmit Audio data (i.e. from
the audio track). See section
cable".
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack firmly into the socket on the back of the
player (Fig. 4).
2. Plug the SCART jack into the corresponding socket on your
replay device.
Component Video
Connection using a Component Video cable ensures a very high
replay quality.
Component Video transmits only Video signals.
1. Plug each of the three jacks into the corresponding sockets on the
DVD-Player (Fig. 5).
2. Plug the jacks into the corresponding socket on your replay
device.
Select the sub-menu "Video Output" from the menu "Video Setup
Page" Activate the option "YUV"
S-Video
Connection using a Component-Video cable ensures a very high
replay quality.
Component Video transmits only Video signals.
1. Plug the S-Video jack into the socket on the back of the player
(Fig. 6).
2. Plug the S-Video jack into the corresponding socket on your
replay device.
Composite-Video
Composite-Video is used to transmit only Video data.
1. Plug the Composite-Video jack into the socket on the back of the
player (Fig. 7).
2. Plug the Composite-Video jack into the corresponding socket on
your replay device.
3. Select the sub-menu "Video Output" from the menu "Video Setup
Page". Activate the option "OFF"
Page 59, "Connecting the Audio
Page 78, "Video output".
Page 78, "Video output".