Connecting The Video Cable - Clatronic dvd 797 Bedienungsanleitung

Themen Starting up

Connecting the Video cable

Fig. 2/9
38
05-DVD 797_GB.indd 38 05-DVD 797_GB.indd 38
ATTENTION:
Mismatching battery types or new and used batteries must never be used
together. Different battery types have different properties. Do not use old and
new batteries together. The mutual use of old and new batteries can shorten the
lifetime of the new batteries and possibly result in leakage of the old batteries.
When disposing of old batteries you should strictly comply with the legal and
environmental regulations applicable in your country. Do not throw batteries
into fi re!
NOTE:
The lifetime of the enclosed batteries may be shortened because of storage.
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity (+ and -).
Start with the negative pole (-).
3. Attach and close the battery compartment cover.
NOTE:
The signals from the remote control are transmitted to the DVD-Player by inf-
rared light. You should therefore take care that the DVD-Player is not exposed to
the direct sunlight. This could make the transmission of signals from the remote
control to the DVD-Player impossible.
Effective range of the remote control
If you want to use the remote control it has to be pointed at the remote control
sensor on the front of the device. The distance between remote control and sen-
sor should not exceed 5m. The angle of the remote control to the remote control
sensor to right, left, top and bottom should not exceed 30°.
The video cable transmits the video data from your DVD-Player to the TV or the
Video-Projector.
There are four different ways of connecting the DVD-Player with your TV/Video-
Projector. Select one of these possibilities to suit your replay unit.
NOTE:
If you do not use a SCART connection it is necessary to make an additional
audio connection for the transmission of the audio data (i.e. the sound).
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack fi rmly into the socket on the back of the player.
2. Plug the SCART jack into the corresponding socket on your playback device.
3. Press the VIDEO button (Fig. 3/1) repeatedly to select the "RGB" setting.
18.08.2008 15:58:18 Uhr 18.08.2008 15:58:18 Uhr