Cleaning And Maintenance; Self-Cleaning Function; Replacing The Limescale Filter - Silvercrest SDBS 2400 B2 Bedienungsanleitung

Cleaning and maintenance

WARNING!
Risk of injury!
► Before cleaning the appliance, disconnect the plug from the mains power
socket!
► Allow the appliance to cool down completely if necessary.
► Never immerse the appliance in water to clean it.
CAUTION
Damage to the appliance!
► To avoid irreparable damage to the appliance, ensure that no moisture can
penetrate the appliance during cleaning.
► Do not use aggressive scouring cleaners or solvents, or a wire brush or
other abrasive objects to clean the surfaces.

Self-cleaning function

♦ Fill the water tank
♦ If the appliance is switched on, set the temperature control
wait until the appliance has heated up.
♦ Hold the iron horizontally over a suitable container or sink.
♦ Press the "Self clean" button
process starts and the "Self clean" button
the steam exit holes in the sole of the iron
present are flushed out.
♦ As soon as the self-cleaning process is complete (after about 80 seconds),
the "Self clean" button
Replacing the limescale filter
After pressing the steam button
replace the limescale filter
The appliance will notify you when the time comes: As soon as the "Anti calc"
button
Proceed as follows:
♦ Set the On/Off switch
♦ Pull the water tank
♦ Pull the limescale filter
SDBS 2400 B2
with water if necessary.
stops flashing.
.
flashes, you need to change the limescale filter
to the position "0" to switch the appliance off.
by the grip
upwards out of the limescale filter shaft.
for about 5 seconds. The self-cleaning
flashes. Steam flows from
. Any impurities that may be
for a total of around 11 hours, it is time to
out of the base station
to "MAX" and
.
.
GB │ IE │
37 ■