Troubleshooting - Silvercrest SDBS 2400 B2 Bedienungsanleitung

Troubleshooting

Fault
The appliance is
not working.
The appliance
produces no/too
little steam.
Water drips out
of the sole of the
iron .
Wet patches occur
on the items being
ironed.
NOTE
► If you are unable to resolve the problem by taking any of the aforementioned steps,
please contact the service department.
SDBS 2400 B2
Possible cause
Fault with the power supply.
The appliance is not switched on. Set the On/Off switch
There is not enough water in the
water tank .
The appliance is not sufficiently
hot.
The temperature control
been set in the
range.
The steam unit has not been used
for a long time or is being used
for the first time.
If steam ironing is paused briefly,
the cooling steam condenses in
the connecting hose
This can lead to drips.
The set temperature is too low for
steam ironing.
Such areas can be caused by
steam condensing on the ironing
board.
Remedy
Check whether the mains plug
is firmly in the mains socket.
the position "1" to switch the
appliance on.
Fill the water tank with water
Wait until the temperature
indicator lamp goes out.
Set a temperature suitable for
has
steam ironing (setting range
–
Hold the steam button
little longer. The steam takes a little
time until it comes out of the sole of
the iron
This is normal. Hold the iron over
a collecting cloth or container
. and press the steam button
Steam will discharge from the
sole of the iron
water after a few seconds.
Then you can continue ironing.
Set a temperature suitable for
steam ironing (setting range
Wipe the wetness from the
ironing board and iron the wet
patches dry (without steam).
to
.
).
down a
.
.
instead of
).
GB │ IE │
39 ■