Removing/Inserting The Battery; Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery; Used Batteries - Parkside PHSSA 20-Li A1 Originalbetriebsanleitung

Removing/inserting the
Battery
1. To remove the battery (4) from the appli-
ance, press the release button (1) on the
battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Only insert the rechargeable
battery once the device is
completely assembled. Risk
of injury!
Checking the charge status
of the rechargeable battery
The battery charge status indicator (3) sig-
nalises the state of charge of the battery (4).
Press the button (2) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (4) when
the red LED on the charge status
indicator (3) is on.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (4) when
the red LED on the charge status
indicator is on.
Charging time is approx. 1 - 2
hour(s).
1. Remove the battery (4) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (4) in the charging com-
partment of the battery charger (5).
3. Plug the battery charger (5) into a
mains outlet.
The red LED on the control display (6)
of the charger (5) comes on when the
battery (4) is loading. If the green LED
on the charger (5) is on, the battery (4)
is charged.
4. When the battery is fully recharged
unplug the battery charger (5) from the
mains.
5. Remove the battery (4) from the charger
(5).
Overview of the control display (6)
on the charger (3):
Green LED lights up without battery in-
serted: Charger ready.
Green LED lights up: Battery such alleged
charged.
Red LED (4) lights up: Battery charging.

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable safe-
ty instructions as well as the environmen-
tal protection regulations and information
(see "Cleaning and Maintenance").
IE NI CY
9