Cleaning; Risk Of Injury; Maintenance; Replacing The Filter - Parkside PHSSA 20-Li A1 Originalbetriebsanleitung

clean the filter (3) as indicated in the
"Cleaning" section.
5. Place the filter holder (2) and filter (3)
back into the collection container (1).
Due to its shape, the filter holder (2)
can only be inserted into the collection
container (1) in one position.
6. Re-attach the collection container (1)
onto the device. Place it on the under-
side of the device and allow it to latch
into the interlock release on the top side
of the device.

Cleaning

Always remove the recharge-
able battery before carrying
out work on the device.

Risk of injury!

Never spray down the device
with water or place it in wa-
ter! Do not use any abrasive
cleaning agents or solvents.
The device could become da-
maged.
• Clean the housing with a dry cloth or
paint brush.
• Tap the filter (3) and clean it with a
brush or compressed air.
If the filter is contaminated and cannot
be cleaned, replace it!
See "Spare parts/Accessories".
• Empty the collection container (1) after
every use.
Clean the collection container (1) with
a damp cloth.
• Always keep the ventilation slit on the
device housing unobstructed otherwise
the device will overheat.

Maintenance

Replacing the filter

If contaminated, replace the filter with a
new one.
New filters can be acquired from the
online shop. See "Replacement parts/Ac-
cessories".
1. Remove the collection container (1) by
pressing the release button (4) and de-
tachingn the collection container (1).
2. Remove the filter (3) from the filter hol-
der (2).
3. Place the new filter into the filter holder.
Ensure the filter is positioned correctly
and securely.
4. Re-attach the collection container (1)
onto the device by placing it on the
underside of the device and allowing it
to latch into the interlock release on the
top side of the device.

Storage

Store the device in a dry place, out of
reach of children.

Wall bracket

(optional)
You can also mount the cordless hand-held
vacuum cleaner on the wall.
• Using dowels, place one screw at the
desired position on a wall.
• The screw head can have a diameter of
6 - 7 mm.
• Leave the screw head protruding at a di-
stance of approx. 10 mm from the wall.
• You can then place the cordless hand-
held vacuum cleaner onto the screw
using the keyhole bore (11) and pull
IE NI CY
9