Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Do not operate the device if dam-
aged or incorrectly assembled!
Replace damaged parts and dirty
filters. See "Spare parts/accesso-
ries".
Ensure that the battery is not insert-
ed! (See section "Inserting/removing
the rechargeable battery")
1. Remove the collection container (1) by
pressing the release button (4) and de-
taching the collection container (1).
2. Check that the filter holder (2) is sitting
securely against the mechanical stop
in the collection container (1) by lightly
pressing the filter holder (2). Due to its
shape, the filter holder (2) can only be
inserted into the collection container (1)
in one position.
3. Check whether the filter (3) is sitting
securely in the filter holder (2). Lightly
press the filter into the filter holder (2).
4. Re-attach the collection container (1)
onto the device. Place it on the under-
side of the device and allow it to latch
into the interlock release on the top
side of the device.
Inserting/removing the
rechargeable battery
Ensure that the cordless hand-held
vacuum cleaner is switched off.
1. To insert the battery into the device,
push the battery along the guide rail
(10) into the device. You will hear it
click into place.
2. To remove the battery from the device,
press the release button on the battery
and pull the battery out.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Checking the charge status
of the rechargeable battery
The battery charge status indicator signali-
ses the state of charge of the battery.
Press the button on the battery. The state of
charge of the battery is displayed by illumi-
nating the 3-colour LED lights of the state of
charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery when the
red LED on the charge status indica-
tor is on.
Attaching the nozzles
Insert the desired nozzle into the front
opening of the collection container (1).
Remove the nozzle by pulling it forward
out of the collection container (1).
Removing the brush nozzle attach-
ment (7) and the universal nozzle
attachment (6)
Remove the attachments (6+7) by
a
pulling them off the crevice nozzle
(8) at a slight angle. This makes it
b
easier to pull the tab (a) over the
nose (b).
GB
IE
19
Werbung
Inhaltsverzeichnis
