Cleaning And Maintenance - Beurer BM 45 Gebrauchsanweisung

• Your last measurement will appear on the dis-
play.
• Press the relevant memory button (M1 or M2).
If you have selected user memory1, the M1 memory
button must be pressed.
If you have selected user memory2, the M2 memory
button must be pressed.
flashes on the display.
The average value of all saved measured values
in this user memory is displayed.
• Press the relevant memory button (M1 or M2).
flashes on the display.
The average value of the morning measure-
ments for the last 7 days is displayed (morning:
5.00 a.m. – 9.00 a.m.).
• Press the relevant memory button (M1 or M2).
flashes on the display.
The average value of the evening measurements
for the last 7 days is displayed (evening: 6.00
p.m. – 8.00 p.m.).
• When the relevant memory button (M1 or M2) is
pressed again, the last individual measurement
is displayed (in this example, measurement 03).
• When the relevant memory button (M1 or M2) is pressed
again, you can view your individual measurements.
• To switch the device off again, press the Start/stop button
or wait 30 sec.
You can exit the menu at any time by pressing the Start/
stop button .
• To clear the memory of the relevant user memory, you must
first select a user memory.
• Start individual measurement access.
• Press and hold the M1 & M2 memory buttons for 5 sec-
onds.
• All the values in the current user memory are
deleted.

8. Cleaning and maintenance

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
31