Power Failure; Cleaning; Servicing (And Nameplate) - Gram KP 660 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für KP 660:

Inhaltsverzeichnis

Verfügbare Sprachen

Power failure

If the power fails, the control will remember the settings.

When power is restored, the cabinet will always start up on the storage program,

irrespective of whether the time and/or chilling program was active prior to the power

failure.

At regular intervals the inside of the cabinet should be cleaned and inspected

thoroughly before restarting. The external cladding is best cleaned with a weak soap

solution. To avoid scratching, do not use scouring powder or similar material. The

compressor compartment and in particular the condenser must be kept free of dust

and dirt. Here, a vacuum cleaner is best. The compressor compartment and

refrigerating element (at the top of the cabinet interior) must not be sprayed with

water. To do so is to risk short-circuiting and damage to electrical parts.

NOTE! Before cleaning, disconnect the cabinet at the wall plug.

Servicing

The refrigerating system and the hermetically-sealed compressor need no inspection

- only cleaning. The panel screen cover can be removed by pushing it upwards. If

refrigeration fails in some way, first check to make sure the power has not

inadvertently been switched off and then check the house fuses. If the cause of the

failure cannot be found, contact your supplier. Give the type name and part number.

TYPE, SER.NO. and PART NO. are given on the nameplate on the inside of the side

panel.

Nameplate

76-504-0648

Inhaltsverzeichnis