Device Description; Initial Use; Mains Connection - Beurer TL 45 Perfect Day Gebrauchsanweisung

5. Device description

1. Fluorescent screen
2. Stand
3. ON/OFF sensor
4. Relax sensor
5. Active sensor
6. Therapy sensor
7. Mains part
connector
8. Mains part

6. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you
notice any damage or faults on the device, do not use it and contact Customer Services or
your supplier.
Setting up the device
Place the device on an even surface. The position should be chosen to ensure a distance
of between 20 cm and 45 cm between the user and the device. The daylight therapy lamp
is most effective at this distance.
Note:
If the device has been in storage or recently transported, keep it for at least two hours at
room temperature before using it.

Mains connection

IMPORTANT
To prevent possible damage to the device, the daylight therapy lamp must be used only
with the mains part described here.
1. Insert the mains part into the mains part connector provided for this purpose on the rear of
the daylight therapy lamp and into a suitable mains socket. The mains part must be con-
nected only to the mains voltage that is specified on the type plate.
2. After using the daylight therapy lamp, unplug the mains part from the mains socket first and
then disconnect it from the daylight therapy lamp.
Note:
• Ensure that there is a mains socket close to the set-up area.
• Arrange the mains cable so that no-one will trip over it.
8
6
5
1
3
4 2
19
7 2