Device Description; Initial Use; Mains Connection - Beurer TL 20 Gebrauchsanweisung

Repairs
Important
• Do not open the device. Do not attempt to repair the device yourself. This can result in serious injury. Fail-
ure to comply with this instruction will void the warranty.
• For repairs, please contact Customer Services or an authorised retailer.
• Do not use the device if it is damaged. If the device is not working, try to solve the problem using the
information in chapter "What if there are problems?". If you are unable to solve the problem, contact Cus-
tomer Services or an authorised retailer.

4. Device description

Overview
1. Fluorescent screen
2. Rear of the housing
3. Stand
4. ON/OFF button
5. Mains part connection
6. Storage slot for stand
7. Holder for using the
stand

5. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact Customer Services or your supplier.
Setting up the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 10 cm and
30 cm between the user and the device. The lamp is most effective at this distance.

Mains connection

• To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains
part described here.
• Insert the mains part into the connection provided for this purpose on the rear of the daylight therapy
lamp. The mains part must only be connected to the mains voltage that is specified on the type plate.
• Plug the mains part into a suitable socket.
• After using the daylight therapy lamp, unplug the mains part from the mains socket first and then discon-
nect it from the daylight therapy lamp.
Note:
• Ensure that there is a mains socket close to the set-up area.
• Ensure that the mains part plug is completely inserted in the mains socket.
• Arrange the mains cable so that no-one will trip over it.
1
13
4
2 6
3
5
7