Device Description; Initial Use - Beurer TL 45 Perfect Day Gebrauchsanweisung

• Remove all packaging material before using the device.
• Light sources are excluded from the warranty.
• Switch-on test: after switching on the device, check if there are any bright flashes, dark areas / shadows
or other anomalies. This is especially important to do once the lamp has reached the expected number of
operating hours. If you notice anything unusual, please contact Customer Services.
• The mains part is part of the medical equipment.
Repairs
IMPORTANT
• Do not open the device. Do not attempt to repair the device yourself. This could result in serious injury.
Failure to comply with this instruction will void the warranty.
• For repairs, please contact Customer Services or an authorised retailer.

5. Device description

1. Fluorescent screen
2. Stand
3. ON/OFF sensor
4. Relax sensor
5. Active sensor
6. Therapy sensor
7. Mains part connector
8. Mains part

6. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact Customer Services or your supplier.
Setting up the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 20 cm and
45 cm between the user and the device. The daylight therapy lamp is most effective at this distance.
Note:
If the device has been in storage or recently transported, keep it for at least two hours at room temperature be-
fore using it.
Mains connection
IMPORTANT
To prevent possible damage to the device, the daylight therapy lamp must be used only with the mains part de-
scribed here.
1. Insert the mains part into the mains part connector provided for this purpose on the rear of the daylight therapy
lamp and into a suitable mains socket. The mains part must be connected only to the mains voltage that is
specified on the type plate.
8
6 5
1
4 3 2
16
7 2