Switching On And Off; Working With The Electric Hedge Trimmer; Cutting Techniques - FLORABEST FHT 600 A1 Originalbetriebsanleitung

GB MT

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
1. For tension relief of the cable,
C
form a loop of the end of the
extension cable and bring this
through the opening at the han-
dle and suspend in the tension
relief at the grip (7).
2. Connect the device to the mains
voltage.
3. Hold the safety switch on the loop
handle (4) and push the On/Off
switch on the grip (6) at the same
time to switch the unit on. The
hedge trimmer will be run at maxi-
mum speed.
4. Release one of the two switches
to switch the trimmer off.
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
• Switch off the equipment immedi-
ately in the event that the blades are
blocked by solid objects, pull out the
power plug then remove the object.
• Always work away from the mains pow-
er outlet. Set the cutting direction before
starting work. Ensure that the power
cable is kept well away from the work-
ing area. Never lay the cable over the
40
hedge, where it could easily be caught
up in the trimmer blades.
• Avoid overstraining the equipment dur-
ing work.
Pull out the power plug imme-
diately if the cable is damaged,
badly twisted or has been com-
pletely cut through.

Cutting Techniques

• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables
cutting in both directions or, with a
swinging action, from one side to the
other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move
the hedge trimmer in a sickle-shaped
movement to the edge of the hedge,
so that cut branches fall to the ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
Cutting Shaped Hedges:
It is recommended that hedges be cut in a
trapezoidal shape, in order to prevent strip-
ping off of the lower branches. This cor-
responds to the natural plant growth and
allows the hedge to thrive optimally. During
cutting, only the new annual growths are
reduced and thus a dense branching and a
good screen will develop.
1. Cut the sides of a hedge first.
D
To do this, move the hedge trim-
mer in the direction of growth
from bottom to top. If you cut
down from the top, the thinner