Switching On And Off; Working With The Electric Hedge Trimmer; Cutting Techniques - FLORABEST FHT 600 B2 Originalbetriebsanleitung

GB

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer is
in contact with no other objects be-
fore switching on.
1. For tension relief of the cable,
form a loop of the end of the
extension cable and bring this
through the opening at the handle
and suspend in the tension relief
at the grip (7).
2. Connect the device to the mains
voltage.
3. Hold the safety switch on the loop
handle (4) and push the On/
Off switch on the grip (6) at the
same time to switch the unit on.
The hedge trimmer will be run at
maximum speed.
4. Release one of the two switches to
switch the trimmer off.
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
• Switch off the equipment immediately
in the event that the blades are blocked
by solid objects, pull out the power plug
then remove the object.
• Always work away from the mains pow-
er outlet. Set the cutting direction before
starting work. Ensure that the power
cable is kept well away from the work-
ing area. Never lay the cable over the
46
hedge, where it could easily be caught
up in the trimmer blades.
• Avoid overstraining the equipment dur-
ing work.
. Pull.out.the.power.plug.im-
mediately.if.the.cable.is.dam-
aged,.badly.twisted.or.has.
been.completely.cut.through.

Cutting Techniques

• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables cut-
ting in both directions or, with a swinging
action, from one side to the other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move the
hedge trimmer in a sickle-shaped move-
ment to the edge of the hedge, so that
cut branches fall to the ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords is
recommended.
Cutting.Shaped.Hedges:
It is recommended that hedges be cut in
a trapezoidal shape, in order to prevent
stripping off of the lower branches. This cor-
responds to the natural plant growth and
allows the hedge to thrive optimally. During
cutting, only the new annual growths are
reduced and thus a dense branching and a
good screen will develop.
1 . Cut the sides of a hedge first. To
do this, move the hedge trimmer
in the direction of growth from
bottom to top. If you cut down
from the top, the thinner branches
will move out, which may result in