Swivelling Out The Blade Beam; Attach The Shoulder Strap; Switching On And Off; Working With The Electric Hedge Trimmer - FLORABEST FHL 900 A1 Originalbetriebsanleitung

On/Off switch and the safety
switch must not be held closed.
They must switch off the motor
when on is released. Should a
switch be damaged, stop work-
ing with the equipment. Ensure
that the mains voltage value
matches the label on the equip-
ment.
Note noise protection and local
specifications. The use of the
equipment on certain days (e.g.
Sundays and national holidays), at
certain times of day (lunch times,
night time quiet periods) or in spe-
cial areas (e.g. health resorts, clin-
ics etc.) is restricted or forbidden.

Swivelling Out the Blade Beam

D
1. Hold the safety blade beam
A
( 1) on the handle to adjust
the blade beam (6).
2. Unscrew the stop lever fixing (4)
from the stop lever (5a).
3. Unlock the stop lever (5a) by
pressing the safety lever (5b).
Press simultaneously on the
safety lever (5b) and stop lever
(5a) to release the safety blade
beam fixing (
4. The safety blade beam (
can now be swivelled out into
the operating position. Use the
stop stages and allow the stop
lever (5a) and safety lever (5b)
to click back in.
5. Screw the stop lever fixing (4)
back into the stop lever (5a).
A
1).
A
1)

Attach the shoulder strap

Attach the shoulder strap spring clip
A
( 15) to the carrying eyelet (
the tubular shank of the device.

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
1. Connect the device to the mains
voltage.
2. To switch on, hold the safety
A
switch (
simultaneously press the on/
off switch (
trimmer will be run at maximum
speed.
3. The equipment will switch off
again when you release on/off
A
switch (
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage
to the cutter bar.
• Always hold the equipment firmly in
both hands, with one hand on the rear
handle and the other on the front han-
dle. Thumbs and fingers must be firmly
around the handles.
GB
A
16) on
13) depressed and
A
14). The hedge
14).
11