Trouble Shooting; Waste Disposal And Environmental Protection; Fault Correction - FLORABEST FHT 600 A1 Originalbetriebsanleitung

Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration
of conformity.
Technical and optical changes may be
undertaken in the course of further de-
velopment without notice. All dimensions,
references and information in this instruc-
tion manual are therefore not guaranteed.
Legal claims made on the basis of the
instruction manual can therefore not be
considered as valid.

Trouble Shooting

Problem
Device does not
start
Device runs with
interruptions
Blades become
hot
Possible cause
Mains voltage not on
On/Off switch (
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (
defective
Blades are blunt
Blades are notched
Too much friction due to
lack of lubrication
Waste Disposal and Envi-
ronmental Protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Electrical machines do not belong
in domestic waste.
Take the equipment to a waste disposal
site. The plastic and metal parts that are
used can be separated out into pure grade,
which allows recycling. Ask our Service
Centre for details (see p.57 for address).
Defective units returned to us will be dis-
posed of for free.

Fault correction

Check plug socket, cable, line and
plug, where appropriate, have repaired
through electrical specialist
6)
Repair by Service Centre
Check the cable and have it changed
by the Service Centre if necessary
Repair by Service Centre
6)
Have the blades (
replaced (Service Centre)
Have the blades (
replaced (Service Centre)
Oil the blades (
GB MT
2) sharpened or
2) checked or
2)
43