Operation; Select Operating Mode; Preselecting The Rotation Speed; Led Display - Parkside PBH 1500 E5 Originalbetriebsanleitung

Tool/chuck:
♦ Pull the locking collar
the tool/wheel-rim chuck
.
♦ Release the locking collar
holder . Check that the tool is properly locked
by pulling it . The tool has radial play because
of its design .
Removing the tool/chuck:
♦ Pull the locking collar
NOTE
Tighten the drill in the wheel-rim chuck
same time . To do this, apply the chuck key
sequence to all of the 3 positions on the wheel-
rim chuck and tighten the tool (e .g . drill) at
the same time .
►
Clamping a tool:
Turn the chuck key
► Removing a tool:
Turn the chuck key
WARNING!
► Do not use the wheel-rim chuck
drilling or chiselling!

Operation

Select operating mode

WARNING!
► Do not press the function selector switch
until the appliance has come to a complete
standstill . Switching between functions while
the tool is still rotating can damage the
appliance .
■ 16 │ GB │ IE
backwards and insert
in the tool holder
. This locks the
on the tool backwards .
at the
in
clockwise .
anticlockwise .
for hammer
Function selector switch:
♦ Press and hold the release button
function selector switch
selector switch so that the required symbol
engages at the arrow mark:
Function
Drilling
Hammer drilling
Chiselling
Chisel position adjust-
ment
Adjusting the chisel position:
You can rotate the tool to the required position for
chiselling using this function .
♦ Turn the function selector switch
position .
♦ Turn the tool in the tool holder
quired position .
♦ Turn the function selector switch
position for the chiselling function .

Preselecting the rotation speed

You can use the rotational speed preselector dial
to preselect the rotational speed . Level 1 (low rota-
tional speed) up to level 6 (high rotational speed) .
Work out the correct settings by carrying out a test .
- Level 3–6: high speed: for hammer drilling/
chiselling in concrete or stone
- Level 1–3: low speed: for drilling in steel or
wood

LED display

■ The green LED lights up when the mains
3a
plug is inserted .
■ The red LED lights up when the carbon
brushes are worn down .
Stop all work and send the appliance to
customer service .
on the
. Turn the function
Symbol
to the
to the re-
to the
PBH 1500 E5