Installing The Body; Adjusting The Brake Linkage - Carson CNB Betriebsanleitung

h. Installing the body
Install the body onto the chassis, using the body clips provided
to hold it in place.
Tuning guide!
Making chassis adjustments
Chassis alignment and geometry are important if you want
your Buggy to perform well. A good performing Buggy means a
Buggy that is easier to drive, too.
Follow our guidelines in this section to get the most out of your
CNB.
i. Adjusting the brake linkage
The brake linkage on your Buggy is preset from the factory;
however, after running the Buggy for a while you may find that
the brake linkage needs adjusting.
Follow the information below to check and adjust the brake
linkage:
With the transmitter and receiver turned on, and the throttle/
brake trim lever centered, the Buggy should roll forward
smoothly (i.e., the brakes should be disengaged). lf the brakes
are dragging when the throttle trigger is at neutral, the brake
discs will wear out very quickly. To ensure that the brakes are
disengaged, always make sure that there is a 1/16" wide gap
between the two rear steel adjustment collars and the brake
levers. Both steel adjustment collars should be adjusted so that
they are equal distance behind each of the two brake levers.
This will ensure that both brake levers engage equally during
braking.
To make adjustments to the brake linkage, simply loosen the
grub screw in the adjustment collars behind the brake levers
Pro tip:
Other than during the break-in period, always make sure that
you install the body when driving your Buggy. lf your Buggy
flips over, the body will help protect the chassis and its compo-
nents.
IMPORTANT
It's very important when making changes to the settings of your
Buggy that you make the settings the same for each side. For
example, if you change the spring tension on the right front
shock, you should change the spring tension on the left front
shock the same amount, etc.
Do not make any changes that are more than 3 degrees from
the initial settings listed or the handling characteristics of your
Buggy will become very poor.
Picture 25
and reposition them, then retighten the grub screws. Moving
the collars forward, toward the brake levers, will result in the
brakes coming on sooner and more forcefully.
CARSON Nitro Buggy CNB 204016
GB
21