Carson CNB Betriebsanleitung Seite 12

Open the battery box cover by removing the retaining clip and
GB
pulling up on the front of the cover. The battery box cover is
hinged at the back for convenience.
Remove the battery holder from the battery box.
Install 4 AA Alkaline batteries into the battery holder, double-
checking to make sure that the polarity is correct.
IMPORTANT: Make sure that the batteries are pushed firmly into
place. They should not be loose. lf for any reason the plug from
the battery holder (male red plug) is not plugged into the switch
(female red plug), plug them together now. The plugs can fit
together only one way.
Remove the four screws from the receiver mounting box cover,
then remove the cover. Uncoil the receiver antenna and feed it
out through the hole in the cover.
Reinstall the cover, making sure not to pinch any of the wires.
Slide the receiver antenna into one end of the plastic antenna
tube and out the other end.
Push the end of the antenna tube firmly into the metal clamp in
the top of the receiver mounting box cover, then gently tighten
the knurled nut to lock the tube into place.
IMPORTANT Leave the excess antenna hanging from the top of
the tube. Under no circumstances should you cut the antenna
shorter.
12 CARSON Nitro Buggy CNB 204016
Picture 4
Picture 5
Picture 6
Picture 7