Double-Check The Steering And Throttle/Brake Controls - Carson CNB Betriebsanleitung

c. Double-check the steering and throttle/brake
GB
controls
PRO TIP: We suggest doing the steering tests while lifting the
front of the Buggy off the ground. This will allow the steering
system to operate smoothly, without any binding.
With the transmitter and the receiver turned on, rotate the
transmitter's wheel forward (to the right). The Buggy's front
wheels should turn right.
IMPORTANT
lf the wheels don't turn right, flip the steering servo reversing
switch on the top of the transmitter to change the direction that
the front wheels turn. Refer to the transmitter photo and
definitions on page 9 if you don't remember how to use the
servo reversing switches.
Rotate the transmitter's wheel backward (to the left). The
Buggy's front wheels should turn left.
Let go of the transmitter wheel. The Buggy's wheels should
return to center.
IMPORTANT
lf the wheels do not point straight ahead (center) after you
return the transmitter wheel to center, turn the steering trim
dial on the transmitter to adjust the wheels so that they point
straight ahead. Refer to the transmitter photo and definitions on
page 9 if you don't remember how to use the servo trim dial.
• Carefully pull the air filter assembly off of the carburettor, so
that you can see the carburettor barrel.
• Pull back on the throttle trigger. The carburettor barrel
should open completely and the brakes should be disen-
gaged (i.e., the Buggy should roll forward smoothly).
• Let go of the throttle trigger and the carburettor barrel
should return to its idle position – open about 1/16" (1 mm).
The brakes should still be disengaged, too. lf not see
page 21 „Adjusting the Brake Linkage".
IMPORTANT
lf the carburettor barrel does not open when you pull back on
the throttle trigger, flip the throttle servo reversing switch on the
top of the transmitter to change the direction.
14 CARSON Nitro Buggy CNB 204016
Picture 10
Picture 11
Picture 12