Preparing To Run Your Model; Final Assembly - Carson CNB Betriebsanleitung

a. Preparing to run your model
IMPORTANT
Before continuing, please double-check that you've read and
understood the warnings. It's important that you understand
this information before preparing to run your CARSON CNB
Buggy. Also, remember, if you have any questions or encounter
any problems, you can contact us using the Customer Service
Information (see last page).
a. Final assembly
Install the tires and wheels onto the chassis, making sure to
tighten the wheel retaining nuts firmly. Notice that the back of
the wheels are molded to key over the hex-shaped wheel hubs.
All four wheels and tires are the same.
Push the telescoping transmitter antenna down into the molded
hole in the top of the transmitter.
Thread the antenna (clockwise) into place and tighten it gently
until it stops.
IMPORTANT: Do not force the antenna into place or tighten
it too strongly. Doing so could cause damage to the antenna
and/or transmitter.
Remove the plastic battery cover from the bottom of the
transmitter.
Install 8 AA Alkaline batteries into the battery tray, double-
checking to make sure that the polarity is correct.
Reinstall the battery cover and set the transmitter aside for
now.
Included:
Completely assembled the CNB with body having been painted
from the inside, decal sheet, EMS-system including E-starter
and 40MHz radio control as well as 3 servos.
Picture 1
Picture 2
Picture 3
CARSON Nitro Buggy CNB 204016
GB
11