Troubleshooting - Concept VA0010 Bedienungsanleitung

EN

TROUBLESHOOTING

1. The device does not work
- Check if the supply cord is properly connected and not damaged.
- Check whether the bag is in the correct position and not outside the vacuum chamber.
- Make sure the lid is closed properly.
2. Air is not removed from the bag completely
- Make sure the open end of the bag is properly inserted in the vacuum chamber. If the edge of the bag overlaps the
gasket of the vacuum groove, the air will not be sucked out, although the seal is tight.
- Check for leaks by immersing the bag in a canister filled with water. Any escaping bubbles indicate a leak. In this
- Do not make additional seals on the sealed sides of the bag. The bags are provided with special seals on the sides
that are tight along the entire length of the outer edge. Attempts to make a new side seal could cause leakage and
entry of air.
3. Air has re-entered the bag after being sealed
the bag, dry and clean the area around the seal and re-seal.
- Items with sharp edges or points may puncture the bag. Wrap food and items with sharp edges or points with soft
4. The bag melts
The sealing element may be overheated after repeated use. After each use, allow the unit to cool down for about 1
minute.
ADDITIONAL ACCESSORIES
The following additional accessories for the unit are available for purchase:
Code:
INSTRUCTIONS AND INFORMATION FOR CORRECT USE OF THE unit
contamination from insects will cause food spoilage. They also cause freezer burn to improperly packed food due to
water evaporation. Vacuum packaging can slow down this process. Vacuum packaging is a scientifically tested food
storing method of storing, which keeps food fresh up to five times longer than other used methods.
VA0010 55