Troubleshooting; Repair & Maintenance; Environmental Protection - Concept SO1010 Bedienungsanleitung

The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects as they may
damage the unit's surface!
Wash the drying screens in warm water with a bit of detergent. If the screens are really dirty, leave them in the water
and then use a soft brush.
Never clean the lid with the fan under running water, do not rinse it, and do not submerge it in water!

TROUBLESHOOTING

Problem
Motor does not run.
Motor has stopped
operating.
ACCESSORIES
The following accessories can be bought with the unit:
Drying screen |42390291, Ord. No.
Note: The drying capacity can be expanded up to 10 drying screens
REPAIR & MAINTENANCE
Any extensive maintenance or repair that requires access to the inner parts of the product must be performed by an expert
service centre.

ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
A symbol on the product or its packaging indicates that this product should not go into household waste.
It must be taken to the collection point of an electric and electronic equipment recycling facility. By making
sure this product is disposed of properly, you will help prevent the negative effects on the environment
and human health that would otherwise result from inappropriate disposal of this product. You can learn more about
recycling this product from your local authorities, a household waste disposal service or in the shop where you bought
this product.
24
Cause
Plug inserted into the mains outlet
incorrectly or insufficiently.
The mains outlet is not live.
Supply cable is damaged.
Improper or insufficient air flow.
Motor overheating fuse activated.
Price: See price list
Solution
Check the plug connection.
Check for voltage, e.g. by connecting another
appliance.
Refer the unit to an authorized service center
for testing and repair.
Disconnect the cable from the socket.
Check and clear the air passage on the inlet
and outlet grilles. Let the unit cool down.
EN
SO1010