Troubleshooting - Klarstein Iceblock Prosmart 9 Bedienungsanleitung

TROUBLESHOOTING

Troubles Possible Causes
The water level indicator
light is flashing because
the water tank is full.
The unit does not
The room temperature is
start when the
higher than the set tempera-
On / Off button
ture (electric heating mode).
is pressed.
The room temperature is
lower than the set tem-
perature (cooling mode).
The doors or windows have
not been properly closed.
There are heat sources
in the room. The exhaust
The device is not
hose has not been con-
cooling properly.
nected or is blocked.
The temperature set-
ting is too high.
The air intake is blocked.
The floor of the installation site
is not flat or not flat enough.
The device is
The noise is caused by
very loud.
the refrigerant circulat-
ing inside the fan.
The room temperature
sensor is defective.
Code E 0
Condenser temperature
Code E 1
sensor is defective.
When cooling, the
Code E 2
water tank is full.
The evaporator tempera-
Code E 3
ture sensor is defective.
When heating, the
Code E 4
water tank is full.
Suggested Remedies
Empty the water from
the water tank.
Reset the temperature setting.
Reset the temperature setting.
Make sure all doors and
windows are closed.
If possible, remove the
heat sources. Connect
or clean the hose.
Reset the temperature setting.
Clean the air intake.
If possible, place the unit
on a flat, level surface.
This is normal.
Replace the room tempera-
ture sensor (the device also
works without the room tem-
perature sensor being intact).
Replace the condenser
temperature sensor.
Remove the rubber stopper
and empty the water.
Replace the evapora-
tor temperature sensor.
Empty the water tank.
EN
35