Troubleshooting - Klarstein Metrobreeze Las Vegas 12 2G Bedienungsanleitung

All manuals and user guides at all-guides.com
Storage
1. Remove the rubber stopper and drain plug cap from the drainage hole and empty
the internal tank. You can also drain the water by leaning the unit.
2. Then switch the unit to low fan mode.
3. Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to
keep the inside of the unit dry and prevents mould from developing.
4. Switch off the unit and unplug the mains plug from the socket.
5. Replace the rubber stopper and drain plug cap.
6. Wind up the cable and tie it together. Place it in the accessory compartment.
7. Disconnect the exhaust hose from the unit and store it safely.
8. Cover the unit and store it in a dry place.
9. Take the batteries out of remote control and store or dispose of them safely. Keep all
accessories with the unit ready for next season.

TROUBLESHOOTING

Note: Do not repair or disassemble the air conditioner yourself. Improper repair will
void the warranty and may result in equipment failure, personal injury and property
damage. Only use the unit as described in this manual and only carry out work
described below.
Problem
The air conditioner does
not work.
Possible cause
There is no electricity.
The water tank is full.
(The overflow indicator
displays „FL".)
The ambient temperature is
too low or too high.
In cooling mode, the room
temperature is lower than
the set temperature. In
heating mode, the room
temperature is higher than
the set temperature.
In dehumidification mode,
the ambient temperature
is low.
Possible solution
Insert the mains plug into
the socket and switch on
the appliance.
Empty the water tank.
Only use the appliance
at temperatures between
7-35 °C (44-95 °F).
Change the set
temperature.
Place the appliance
in a room with a room
temperature above 17 °C
(62 °F).
EN
43