Operation; Connecting The Compressed Air Supply; Filling The Blasting Material Tank; Fitting The Collecting Bag For Sandblasting Material - Parkside PDSP 1000 C3 Originalbetriebsanleitung

 Operation
 Connecting the compressed

air supply
NOTE
gun must be operated with compressed air that
1
is clean, oil-free, moisture-free and at a maximum
pressure of 6.3 bar. To regulate the compressed air
supply, a pressure regulator and filter should be
used (e.g. Parkside Compressed Air Maintenance
Unit PDWE 8 A1).
Connect the air-driven sandblasting gun
„ 
to a suitable compressed air supply. Plug the
quick-connect plug on the supply hose into the
2
barbed fitting
1
gun . The plug locks into place automati-
cally.
NOTE
is set to "0" before you connect the device to
7
your compressed air supply.
 Filling the blasting material

tank
ATTENTION
on the blasting material tank
9
any other settings, the device must be completely
depressurised and the sandblasting gun must be
disconnected from the compressed air supply
(e.g. compressor).
Only use compatible blasting material for your
„ 
sandblasting work
NOTE
blasting material with no risk of silicosis (ground
blast furnace slag) with a grit size of 0.2 mm
to 0.8 mm.
Ensure that the blasting material
„ 
absolutely dry and not too coarse-grained.
„ 
292181 Druckluft-Sandstrahlpistole_content_LB8.indb 19
The air-driven sandblasting
1
on the air-driven sandblasting
Ensure that the rotary control
Before opening the screw cap
or changing
8
.
14
We recommend using
is
14
The maximum grit size is
NOTE
0.8 mm.
Open the screw cap on the
„ 
tank by turning the cap anticlockwise.
8
Fill the desired quantity of blasting material
„ 
into the blasting material tank
Take care not to overfill the tank: the maximum
„ 
tank capacity is 900 ml.
Replace and close the screw cap
„ 
blasting material tank
wise. Ensure that the screw cap is properly
seated and tightly closed.
NOTE
BLASTING MATERIAL GRIT SIZE
The larger/coarser the grit size of the blasting
† 
material used, the less precise the dirt removal
process. The blasting material included is small
and is very suitable for the removal of rust
bloom or soiling. Finer blasting material is
also gentler on the surface of the material and
abrasion is confined to the surface.
For larger areas of rust, coarser blasting mate-
rial should be used, which can be purchased
from larger stockists. Attention: do not exceed
the maximum grit.
 Fitting the collecting bag

for sandblasting material
Using a screwdriver, attach the collecting bag
„ 
to the device with the screw clamp included
4
in the package contents
 Selecting and fitting

attachments
Select the attachment that is the best tool for the
„ 
job in hand ( , ,
10 11 12
Fit your chosen attachment firmly to the blasting
„ 
nozzle , taking care to ensure that no air
6
can escape at the sides.

Operation

blasting material
9
14
.
8
on the
9
by turning it clock-
8
.
5
, ).
13
GB/IE/NI 19
29.11.17 18:34