Hazards Caused By Flying Parts; Hazards Caused By Entanglement; Hazards During Operation - Parkside PDMFW 15 A1 Originalbetriebsanleitung

Save all warnings and instructions for future
reference.
■ The user must evaluate the specific risks that
may arise due to different kinds of use.
■ Please ensure that you have read and understood
the safety instructions before fitting, operating,
repairing, servicing or replacing any accessories
and before working near the compressed air
tool. Failure to do this can result in serious
bodily injury.
■ The compressed air tool should only be set up,
adjusted or used by adequately qualified and
trained operators.
■ The compressed air tool may not be modified.
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator.
■ Never use damaged compressed air tools.
Maintain compressed air tools with care. Check
regularly whether moving parts function correctly
and do not jam; check whether any parts are
broken or damaged to an extent that the com-
pressed air tool will no longer operate correctly.
Check signs and labels for completeness and
readability. If damaged, have parts repaired or
replaced before using the compressed air tool.
Many accidents are caused by poorly main-
tained compressed air tools.
Hazards caused by flying parts
■ If a workpiece or accessory of the compressed
air tool breaks, parts can be flung out at high
speeds.
■ Always wear impact-resistant safety goggles
during operation, when replacing accessory
parts or during repair or maintenance of the
compressed air tool. The level of the required
protection must be evaluated separately for
each individual task.
■ You must ensure that the workpiece has been
securely fixed in place.
│ GB │ IE
■ 18
■ Ensure that sparks and fragments created during
work do not constitute any hazard.
■ Separate the compressed air tool from the com-
pressed air supply before replacing the attach-
ment or accessories or before you adjust the
settings, service or clean the tool.
■ Ensure that no dangers are created for other
persons either.

Hazards caused by entanglement

■ Be careful to avoid entanglement!
Suffocation, scalping and/or cut wounds can
occur if loose clothing, jewellery, necklaces, hair
or gloves are not kept away from the machine
and its accessories.

Hazards during operation

■ When using the compressed air tool, the opera-
tor's hands can be subject to hazards such as
cuts, grazing and heat. Wear suitable gloves to
protect your hands.
■ The operator and maintenance personnel must
be physically capable of handling the size,
weight and power of the compressed air tool.
■ Hold the compressed air tool correctly: be
ready to counteract any normal or sudden
movements – keep both hands ready.
■ Keep proper footing and balance at all times.
■ Prevent unintentional starting. If the air supply is
interrupted, switch off the compressed air tool
using the On/Off switch.
■ Use only the lubricants recommended by the
manufacturer.
PDMFW 15 A1