Operation; Before Use; Using The Tyre Inflation Gauge - Parkside PDSS 13 D4 Originalbetriebsanleitung

WARNING! RISK OF EXPLOSION!
■ Never use petrol or other flammable liquids
to clean the product! Vapours remaining in
the product can be ignited by sparks and
cause the appliance to explode. Do not work
with the product in areas at risk of explosions,
or in areas where flammable liquids, gases or
dusts are located. Do not work on materials
that are or could be potentially flammable or
explosive.
■ Please ensure that you have read and under-
stood the safety instructions regarding multiple
hazards before installation, operation, repair,
service and replacement of any accessories
and before working in the vicinity of the product.
Otherwise, there is a risk of serious physical
injuries.
■ The product should only be set up, adjusted
or used by adequately qualified and trained
operators.
■ The product may not be modified.
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator.
■ The product must be serviced regularly to check
that all required usage and safety instructions
for pneumatic tools, rated values and markings
such as rated speed or rated air pressure are
legibly marked on the product. The user must
contact the manufacturer to obtain replacement
labels if necessary.
■ Do not overload the product.
■ Never use hydrogen, oxygen, carbon dioxide or
other gas in cylinders as an energy source for
this product, as this could lead to an explosion
and cause serious injuries.
■ 28 │ GB │ MT
DANGER!
■ Keep your hands and other limbs away from
the rotating parts.
This can lead to a risk of serious injury.

Operation

Before use

NOTE
► The product may only be operated with
cleaned compressed air free of condensate
and oil. The maximum working pressure of
8 bar on the product must not be exceeded.
► The compressed air source must be equipped
with a pressure reducer so that you can regu-
late the air pressure.
♦ Connect the product to a suitable compressed air
source by attaching the quick-connect coupling
on the supply hose to the connector nipple
on the product.
The connection locks automatically.
Using the tyre inflation gauge
♦ Push the valve connector
♦ Press the trigger
♦ Release the trigger
Read the tyre pressure from the manometer
♦ If there is too much air (pressure too high) in
the object being inflated:
Press the deflation valve
♦ Press the lever of the valve connector
and pull the valve connector
♦ Disconnect the product from the compressor
after completing your work.
onto the valve.
to start the air flow.
to stop the air flow.
to release air.
down
off the valve.
PDSS 13 D4
.