Device-Specific Safety Instructions For Air-Driven Sandblasting Equipment - Parkside PDSP 1000 C3 Originalbetriebsanleitung

General safety instructions
 Device-specific safety

instructions for air-driven
sandblasting equipment
Before setup or first use, check the
„ 
device for any damage. Do not start
using the device if it has any obvious
defects.
Keep children and other persons out
„ 
of the work area while the device is
being used. If you are distracted, you
could lose control of the device.
DANGER OF INJURY! PROHIBITED
„ 
MISUSE! Do not point the device at
people and/or animals.
Wear a dust mask!
„ 
Wear protective goggles!
„ 
Wear protective gloves!
„ 
Wear protective clothing!
„ 
EXPLOSION HAZARD!
„ 
The air-driven sandblasting gun must
not be used in an environment where
gases, naked flames, fire or gas-
driven water heating systems are
present.
NO SMOKING!
„ 
Always work in a room with adequate
„ 
ventilation.
Do not use oxygen or combustible
„ 
gases as a source of energy.
Never exceed the maximum working
„ 
pressure of 6.3 bar.
18
GB/IE/NI
292181 Druckluft-Sandstrahlpistole_content_LB8.indb 18
RECOIL HAZARD!
High working pressures can produce powerful
recoil forces that can in some circumstances create
hazards due to continuous stress and strain.
DANGER OF INJURY!
„ 
Disconnect the device from the compressed air
supply before carrying out repair and servicing
or moving the device.
DANGER OF INJURY!
„ 
Disconnect the device from the compressed air
supply before filling with blasting material.
Please also follow the safety
NOTE
instructions from the blasting material manufacturer.
Only use materials that are compatible
„ 
with the air-driven sandblasting gun.
1
Always use suitable blasting material!
ATTENTION! Device produces clouds of dust.
„ 
Take precautions before use!
Ensure that blasting material is collected for
„ 
disposal to avoid polluting the environment.
Do not remove any device labels/type plates.
„ 
These are important for safety.
If you do not have experience with using the
„ 
device, you should seek training to ensure you
can use it safely.
POISONOUS DUSTS!
Working with harmful/poisonous dusts represents
a health hazard for the device operator or persons
present in the vicinity of the work area.
ATTENTION
Ensure that the device is
disconnected from the compressed air supply when
not in use, when replacing accessory parts or
carrying out repairs. The air hose must not be
under pressure.
29.11.17 18:34