Advanced Settings; After Use; Attaching The Carry Strap - VOLTCRAFT KBM-700 Bedienungsanleitung

5. Press and hold the
i) Advanced settings
1. Press and hold the
enter advanced settings from pH or TDS mode.
2. In pH mode, press the
or button to select "USA" or "NIST". Confirm your selection with the
3. Press the
firm your selection with the
4. In TDS mode, press the
or button to select the ratio in the range 0.5 - 1.0. Confirm your selection with
the button.
5. To restore the meter to its factory settings, press the
the calibration standard and "Auto Lock") will be reset.
j) After use
• After use, rinse the conductivity cell or pH electrode with distilled water, dry well and seal
with the soaking bottle.
• The redox probe electrodes and the pH electrode must be kept moist after you have finished
taking a measurement. Rinse them with distilled water and screw back the soaking bottle
with the sleeve. Ensure that the soaking bottle contains sufficient soaking solution. If neces-
sary, top up the soaking solution.
k) Attaching the carry strap
You can use the carry strap to carry the meter and hang it on your neck.
• Secure the carrying strap to the holder (1) on the front of the meter. Use the buckle to
secure it in place.
36
button to exit storage mode and return to measuring mode.
(5) and
button (2) to select the calibration standard. Press the
button (4) to turn the automatic freeze function ("Auto Lock") on or off. Con-
button.
button to determine the conductivity/TDS ratio. Press the
(6) buttons simultaneously for approx. 3 seconds to
button (7). All settings (apart from
button (3).