Initial Operation; Commissioning; Basic Setup Settings - VOLTCRAFT SL-400 Bedienungsanleitung

Initial operation

Inserting the batteries
Before the initial operation of this meter, you must first install a new 9V block battery.
Battery installation is described in the „Maintenance and cleaning" section.
Power unit operation
For long-term measuring operations, you have to use the enclosed power pack unit
(e.g. GM-090150).
Plug the power pack unit into the DC socket on the side (14) and connect it with a
suitable mains outlet.

Basic setup settings

The sound level measuring device SL-400 has an integrated data logger. The data
logger can record measuring values with time stamp. Upon commissioning, you
have to set the time and date.
A) To make the basic settings, proceed as follows:
- Turn the measuring device off (Taste 11)
- Keep the button „SETUP" depressed and turn the device on. Keep both buttons
depressed until „TIME" appears on the display.
- After letting go of both buttons, the setup menu with the default date display
appears.
- To access the individual setting points, press „SETUP" until the
desired parameter appears.
- You have to confirm and complete your settings by pressing
„HOLD" for saving the data. Then the setup menu is terminated and
the measuring display appears.
B) Setting the time (minutes)
- In the SETUP menu, press the button „SETUP" 1x.
- The display for setting the minutes „m" appears.
- Press the „LEVEL" button to set the current minute time. Keep the
button depressed to set the value faster. The values ascend and
start again at the beginning.
- Switch to the next setting with the button „SETUP", or complete
your setting with the button „HOLD".
26